6. From the rear of the computer, disconnect the speaker cable from the system board (1), and then push
the connector end of the cable through the hole (2) that allows the cable to route to the front of the
chassis.
7. Remove two Phillips screws (1) that secure each speaker to the computer.
8. Pull the speaker cable through the hole in the chassis (2).
9. Remove the speakers from the computer.
To install the speakers, reverse the removal procedures.
20-models
The speakers are located at the bottom of the computer behind the speaker cover. Two separate speakers are
each secured by two Phillips screws.
To remove the speakers:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 21).
2. Remove the stand (see Stand on page 21).
3. Remove the rear port cover (see Rear port cover on page 23).
Speakers 43
To Next Page
Loading...
