M.2 solid-state drive
For a list of available solid-state drives, see Mass storage devices on page 11.
To remove the M.2 solid-state drive:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 21).
2. Remove the stand (see Stand on page 21).
3. Remove the rear port cover (see Rear port cover on page 23).
4. Remove the Phillips screw (1) that secures the drive to the computer.
5. Pull the drive away to remove it from the socket (2).
To install the solid-state drive, reverse the removal procedures.
28 Chapter 4 Removal and Replacement Procedures
To Next Page
Loading...
