20-inch models
The webcam pops up from the top of the computer. To remove the webcam, remove the webcam rear cover,
four screws, and disconnect the cable from the connector on the webcam.
For a list of available webcams, see Illustrated parts catalog on page 8.
To remove the webcam:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 21).
2. Remove the front bezel (see Display panel in 20-inch models on page 50).
3. Remove the two Phillips screws (1), that secure the webcam to the computer.
4. Disconnect the cable from the webcam (2).
5. Remove the webcam from the computer (3).
To install a webcam module, reverse the removal procedures.
Webcam 57
To Next Page
Loading...
