Example 2-1 Overview of a Service Processor Login Session
The following output shows a sample login session for a server with the service processor
hostname of “hpsys-s”.
> telnet hpsys-s
Trying...
Connected to hpsys-s.rsn.hp.com.
Escape character is ’^]’.
Local flow control off
MP login: Username
MP password:
Welcome to the
S Class 16K-A
Management Processor
(c) Copyright 1995-2001 Hewlett-Packard Co., All Rights Reserved.
Version 0.23
MP MAIN MENU:
CO: Consoles
VFP: Virtual Front Panel
CM: Command Menu
CL: Console Logs
SL: Show chassis Logs
HE: Help
X: Exit Connection
MP>
Procedure 2-1 Logging in to a Service Processor
This procedure connects to and logs in to the service processor (MP or GSP) for a server complex
by using telnet to access the customer LAN.
If connecting through the local RS-232 port, skip Step 1 (instead establish a direct-cable connection)
and begin with Step 2.
1. Use the telnet command on a remote system to connect to the service processor for the
server complex.
You can connect directly from the command line, for example:
telnet sdome-g
or run telnet first, and then issue the open command (for example, open sdome-g) at
the telnet> prompt.
All telnet commands and escape options are supported while you are connected to the
service processor.
2. Login using your service processor user account name and password.
GSP login:Username
GSP password:Password
16 Using the Service Processor
To Next Page
Loading...
Need help?
General