Enter Q (or lower-case q) as a response to any menu prompt to exit the prompt and return
to the previous sub-menu.
You can do this throughout the service processor menus, including the console menus,
various command menu prompts, and the log and VFP menus.
NOTE: From the Command menu prompt (GSP:CM> or MP:CM>) you must enter MA (not
Q) to return to the Main menu. However, you can enter Q or q to cancel any command.
• Control-]
Escape the service processor connection and return to the telnet prompt.
At any time during your telnet connection to a service processor, you can enter the ^]
(Control-right bracket) escape sequence.
This key sequence returns you back to the telnet prompt. At the telnet> prompt you
can use the following commands:
— ? – Print telnet command help information
— close – Close the current connection
— quit – Exit telnet
To return to the service processor connection, enter return (or enter) one or more times.
Using Service Processor Menus 19
To Next Page
Loading...
Need help?
General