10
Connecting the hp digital projector xb31 to a
computer
Connect the power cord to the
projector and a power outlet.
Connect the black end of the
video cable to the projector.
Connect the blue end of the video
cable to the PC; optionally, to
have the remote control function
as a mouse, connect the USB
connector to the PC.
Start the projector; after a 30-
second warm-up it will search for
a video signal.
If no video signal is found, you
may need to set up the PC to
send a video signal out the video
port.
installation
b31
CAUTION!
Unplugging the projector while
the fan is running may reduce
lamp life.
NOTE: For best performance,
configure the display
mode of your computer’s
graphic card to
1024×768 resolution.
Ensure the timing of the
display mode is
compatible with the
projector. Refer to the
“hp xb31 compatibility
modes” section on
page 35.
To Next Page
Loading...
