HP Series 200 - Page 141

manager ...1-31, 1-35, 2-17
reset ...2-15
setting ...1-35
user ...1-35, 2-17
PC used as a console device ...A-3 – A-4,
A-6 – A-7
physical address
See station address
pin-outs for cables ...A-2, A-5 – A-22
ping ...1-34, 1-41, 1-43, 3-16, 3-18
point to point
See also WAN
port
disable ...1-28
See also interface
port failure ...3-5
ports ...2-3
power ...C-2
power cord ...1-3, 1-7, 1-23
Power LED ...3-9
power, auto-sensing ...2-4
PPP ...2-2
prompt, NCL ...1-35
protocol, unsupported ...2-2
Q – R
Quick Configuration utility ...1-28 -- 1-29
Quick remote
See configuration
rack mount ...1-7 – 1-9
RAM, battery-backed ...2-19
reboot
See boot
regulatory ...1-2
remote bridge ...A-3, A-13
Remote devices ...1-4
remote signal & sense ...2-9, 3-5
remote terminal
See Telnet
reset button ...1-29, 2-8, 2-10, 2-13 – 2-15,
2-19, 3-4 -- 3-5, 3-9 -- 3-10, 3-14
reset, password ...2-15
resetting ...2-14 -- 2-15
resetting, caution ...3-14
restart
See boot and resetting
retainer, AUI ...1-12, 1-13
Rget commands ...1-41 – 1-42
Rgetatr ...1-42
Rgetda ...1-42
ring error ...2-9, 3-5
ring interface rate ...3-5
routing tables ...3-16
RS-232 cable ...A-3 -- A-7, A-12
RS-232 console port ...A-3 -- A-4, A-6 -- A-7
RS-232 WAN interface ...C-4
RS-422 WAN interface ...A-3, A-9, A-13 --
A-15, C-4
RS-449 WAN interface ...C-4
rubber feet ...1-7, 1-12
Rx LED ...3-9
S
Safety ...1-2
safety approvals ...C-4
SAS
See FDDI SAS
screws ...1-7
self-test ...1-23, 2-8, 2-15, 2-19,3-4, 3-5, 3-10,
3-14
failure ...3-6 – 3-8
LED ...1-24, 3-9
monitor ...3-7
serial ports and links
See WAN
server only ...1-33
server, Bootp
See Bootp server
severity, events ...1-37
Simple Network Management Protocol
See SNMP
Single-attach station
See FDDI SAS
Single-height router ...1-8, 1-12, 1-23
single-height router, back panel ...2-6
single-height router, LEDs ...2-7
Smartboot ...1-10, 1-22, 1-26
Index
5