3. Remove the TouchPad and cable.
Reverse this procedure to install the TouchPad.
Card reader board
Description Spare part number
Card reader board (includes cable) 828821-001
Before removing the card reader board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 22).
5. Remove the battery (see Battery on page 23).
6. Remove the speakers (see Speakers on page 28).
Remove the card reader board:
1. Release the ZIF connector (1) to which the card reader board cable is attached, and then
disconnect the card reader board cable from the system board.
2. Remove the Phillips PM2.0×2.7 screw (2) that secures the card reader board to the top cover.
30 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
