Autoloader Operation
111SSL1016 Tape Autoloader Reference Guide
To set Auto Clean:
1. On any Web Administration page, click Configurations.
2. If a checkmark appears in the box next to Enable Auto Clean, the option is
enabled. To disable Auto Clean, click the box to remove the checkmark. If no
checkmark appears in the box next to Enable Auto Clean, the option is
disabled. To enable Auto Clean, click the box to enter a checkmark.
3. Click submit.
Note: A cleaning tape should be present in the cleaning tape slot to configure Auto
Clean. When Auto Clean is turned off, the cleaning tape is ejected to the mailslot.
To Next Page
Loading...
