Autoloader Operation
91SSL1016 Tape Autoloader Reference Guide
View Firmware Version
To view the firmware version:
1. On the main menu, scroll to Status. (See Figure 61.)
2. Press Enter.
3. On the Status submenu, scroll to Autoloader Info. (See Figure 62.)
4. Press Enter.
5. On the autoloader Info submenu, scroll to Version. (See Figure 63.)
6. Press Enter.
A list of messages similar to the following screen appears.
Figure 65: Autoloader version messages
Table 9: Autoloader Version Messages
Firmware The number indicates the firmware version.
EDC The number indicates the Error Detection Code that
was generated when the firmware was installed. The
autoloader uses this number to verify that the firmware
and the memory holding the firmware are good.
HW Rev The number indicates the hardware version.
ME Rev The number indicates the mechanical version.
Firmware: V7.0
EDC: 575A49B8
HW + ME Rev: 1 1
To Next Page
Loading...
