Tape Drive Cleaning
125SSL1016 Tape Autoloader Reference Guide
6. On the Cleaning Tape submenu, scroll to Auto Clean On/Off.
If Auto Clean is enabled, the menu item appears as Auto Clean On. If Auto
Clean is disabled, it appears as Auto Clean Off.
7. To change the setting, press the up or down scroll key once.
8. Press Enter.
Software
Set the cleaning option in your software application (if available) so that the
software monitors drive cleaning. If your application software supports automatic
cleaning, store a cleaning cartridge in the slot specified by the application.
Note: If automatic cleaning is enabled in your application software, make sure the
Auto Clean option is disabled on the autoloader either via the LCD front panel or Web
Administration.
To Next Page
Loading...
