Autoloader Operation
98 SSL1016 Tape Autoloader Reference Guide
3. On the Configuration submenu, scroll to I/E Slot.
Figure 75: Configure Import/Export Slot
4. Press Enter.
If a check appears next to Import/Export Slot, the I/E slot is enabled. If no
checkmark appears, the I/E slot is disabled.
a. To leave the I/E slot unchanged, press Escape.
b. To change the I/E slot, press Enter.
Any change requires a power cycle of the autoloader and reconfiguration of the
ISV software. If the autoloader is not power cycled:
■ The changes will not occur.
■ The front panel red LED flashes and displays a “Please power cycle”
message.
When the I/E slot is enabled, Slot 16 is designated as the I/E slot, when two
magazines are present.
Cleaning Tape
Compression
I/E Slot
Security
To Next Page
Loading...
