To Next PageTo Next PageWhat to do if my HP T750 G4 NA/JP UPS is overloaded?
If your HP UPS is overloaded, it means the power requirement exceeds the UPS capacity (greater than 105% of nominal). To resolve this, remove some of the equipment from the UPS. The UPS will continue to operate, but might shut down if the load increases. The alarm will reset when the condition becomes inactive.
Why does my HP T750 G4 NA/JP have a battery fault?
A battery fault in your HP UPS can occur for a couple of reasons: * The batteries in the UPS might be disconnected. Verify that all batteries are properly connected. If the error persists, note the alarm message and the UPS serial number, and then contact your service representative. * The end of battery life might be reached. If this is the case, contact your service representative for battery replacement.
What to do if my HP UPS has a short-circuit fault?
If your HP UPS indicates a short-circuit fault, it means a short-circuit has occurred. Check the device connection or integrity. If the error persists, note the alarm message and the UPS serial number, and then contact your service representative.
How to fix a fan fault on my HP T750 G4 NA/JP UPS?
If your HP UPS is showing a fan fault, check that no object is blocking the fan. If the error persists, note the alarm message and the UPS serial number, and then contact your service representative.
What does it mean if my HP T750 G4 NA/JP has a charger fault?
If your HP UPS has a charger fault, it means the UPS is no longer charging the battery. Note the alarm message and the UPS serial number, and then contact your service representative.
Lists the standards the UPS complies with, including UL, IEC, FCC, and IEEE.
Explains common symbols used on the UPS for warnings and important instructions.
Outlines safety precautions for installing and operating the UPS, including electrical and environmental factors.
Details specific handling and maintenance precautions, especially regarding battery replacement.
Details how to configure UPS settings like output voltage, alarm, and sensitivity using the LCD interface.
Provides instructions for connecting the internal battery module, including safety precautions.
Steps for starting the UPS, checking status, and verifying normal operation.
A table detailing common operation status faults, their possible causes, and recommended actions.
Provides safety recommendations and precautions for replacing the UPS battery module.
General
