37
2 System Features
Network
Network
All HP Vectra VLi 8SF PC models and some VLi 8 models are supplied with
a 10/100 3Com 3C905B-TX network solution.
This network solution is a 32-bit PCI Ethernet Controller with advanced
manageability capabilities. It features full-duplex, automatic 10/100 BT port
selection, Remote Power-On (RPU), and Remote Wake-Up (RWU).
VLi 8 Models
On HP Vectra VLi 8 PC models, the network solution is deployed as an
accessory board (part number D7506A), installed in PCI slot #3. The card
has an optional Boot ROM for diskless node operation.
NOTE A 3COM LAN Boot ROM is integrated in the BIOS ROM chip on the system
board. As a result, it is not necessary to insert a Boot ROM chip into the LAN
card to perform a Remote Boot.
Connectors
The 10/100BT connector is located on the rear of the PC.
A Wake On LAN (WOL) connector is located on the backplane (refer to page
23 for its location).
For more information on network technology, refer to the Technical
Reference Manual - Vectra Technology.
To Next Page
Loading...
Need help?
General