HP VR Backpack G2 - Power Connector (DC-In) and Cable

Power connector (DC-in) and cable
Table 5-13 Power connector description and part number
Description Spare part number
Power connector and cable L05345-001
Before removing the power connector and cable, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 14).
2. Remove the top cover (see Top cover on page 14).
3. Remove the graphics fan (see Fans on page 16).
4. Remove the WLAN antenna (see WLAN antenna on page 21).
5. Remove the battery (see Battery on page 24).
6. Remove the heat sink (see Heat sink on page 26).
7. Remove the WLAN module (see WLAN module on page 22).
8. Remove the system board (see System board on page 30).
Remove the power connector and cable:
1. Remove the two Phillips M2.5 × 4.5 screws (1) that secure the power connector bracket to the computer.
2. Remove the bracket from the computer (2).
3. Pull the power connector away from the side of the computer to remove it (3).
Reverse this procedure to install the power connector and cable.
Component replacement procedures 35