5. Remove the six Torx screws securing the top cover (2).
6. Insert a thin, at and non-conductive prying tool into the small gap between the HDMI and USB port, and
then pry the cases apart.
CAUTION: Use a non-conductive tool. A conductive tool can damage the system board, chassis or
components.
NOTE: There are internal retaining clips on the top case that may break when the case is pried apart.
7. Lift the top cover (1) slightly and turn the top cover over to separate the cover from the unit (2).
8. Gently disconnect the LED cable next to the LED display on the underside of the top cover, (3) and remove
the top cover.
Reverse this procedure to reassemble the top cover.
Component replacement procedures 15
To Next Page
Loading...
