Thermal shutdown (hot)
Items Procedures
Symptoms
Similar to fan runs constantly issue
(Fan runs constantly on page 82)
●
System shutdown
●
Abnormal heat
●
Continually running fan
●
Decreased computer
performance
Possible causes
BIOS not up to date, thermal condition (fan, air ow)
Troubleshooting steps
1. Update BIOS and drivers (4. Update BIOS and drivers on page 34) and reset BIOS to default.
BIOS may implement new fan characteristics and updates for other component.
2. Perform a hard reset (8. Hard reset on page 41). Performing a hard reset can reset
recorded thermal values in memory.
3. Determine whether you are using a correct AC adapter.
4. Be sure to turn power o completely when putting a notebook in a travel bag.
Thermal-related issue
1. Verify thermal condition:
a. Check fan and connection. Reseat fan cable.
b. Be sure that no obstructions or dust are in heat sink fan, n, or vent.
c. Be sure that the notebook is not sitting on a hot surface that blocks vent intakes.
d. Test fan using HP PC Hardware Diagnostics (UEFI) tool (6. HP Hardware Diagnostics
and Tools on page 35). Be sure that the fan is not producing a loud noise and that fan
blades spin correctly.
e. Test with a veried working fan.
f. Remove old thermal compound and pads, and replace properly with new pads.
2. Verify thermal solution:
○
Use Thermal Monitor tool (available only to authorized service providers/technicians)
to run stress test (processor and GPU) and verify that thermal sensors are within
limits after thermal condition is serviced.
Stuck power button
Items Procedures
Symptoms
●
Rear power indicator light is on
●
Will not turn on when power
button is pressed
●
Automatically powers on
Possible causes
Sticky or defective power button.
Troubleshooting steps
General actions
1. Perform a hard reset (8. Hard reset on page 41).
2. Perform a soft reset if system can turn on.
The sections below are intended for authorized service providers/technicians.
1. Disassemble the unit.
2. Inspect power button on the external case and on the system board to make sure these
buttons move freely.
Common issues and possible solutions 83
To Next Page
Loading...
