HP Z VR Backpack G1 - Page 33

12. Grasp the edge of the memory module (2), and then gently pull the module out of the slot. Use the same
procedure to remove both memory modules.
CAUTION: To prevent damage to the memory modules, hold the memory modules by the edges only. Do
not touch the components on the memory modules.
To protect a memory module after removal, place it in an electrostatic-safe container.
Reverse this procedure to install a memory module.
IMPORTANT: Memory modules are in a stacked conguration. If only one module is installed it must be in the
bottom memory socket.
Component replacement procedures 23