CAUTION: Insert or remove the carrier (with a disk drive) only when the workstation is shut
down. Other procedures may result in system hangs, data loss, or even drive damage. The
component supplier’s user guide describes a procedure for inserting or removing the carrier (with
drive) while the workstation is booted and then powering the drive via the power switch on the
enclosure. However, Microsoft Windows XP and Windows Vista do not support this action.
a.
Insert the key (1) and turn it clockwise (2).
Figure 5-24 Unlocking the carrier
b.
Press on the left side of the door to open it (3).
c.
Remove the drive carrier.
d.
If shipping the unit, lock the carrier by inserting the key and turning it counterclockwise (3).
CAUTION: Always lock the drive before shipping or moving the computer. Failure to do so
might result in damage to your removable hard drive system.
2.
Follow the procedures listed in the
Predisassembly for drives on page 79 section.
CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or
data loss.
NOTE: For better clarity, the figures in this section do not show the front bezel. However, you do
not need to remove the front bezel to remove the DX115 unit.
ENWW
Removing and installing components
91