Installing an expansion card
Visit http://www.hp.com/go/quickspecs to learn which graphics cards are supported in the computer,
how much memory each graphics card includes, and graphics card power requirements.
To install an expansion card:
1.
Prepare the computer for servicing by following the
Predisassembly procedures on page 69.
CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or
data loss.
2.
Remove the access panel (see
Removing the access panel on page 72).
3.
Push the expansion card retention clamp levers down on the outside of the chassis to release the
retention clamp, as shown in the figure below.
Figure 5-74 Releasing the retention clamp
128 Chapter 5 Replacing components ENWW
To Next Page
Loading...
