3.
If you are installing a new DX115 unit, remove and discard the counter-sunk shipping screw on
the side of the DX115 case.
Figure 5-33 Removing the shipping screw
4.
Install four (supplied) M3 x 5mm screws (black) in the lower four mounting holes of the DX115
case. (See
Locating extra guide screws on page 81 for screw locations.)
Figure 5-34 Installing the guide screws
5.
Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward
the front of the computer until it locks into place.
Figure 5-35 Installing the DX115 unit
96 Chapter 5 Replacing components ENWW
To Next Page
Loading...
