8.
Connect the power cable (1) and data cable (2) to the rear of the DX115 case.
Figure 5-38 Connecting the power and data cables
9.
Carefully rotate the drive cage back down to its normal position.
CAUTION: Check clearances on the cables when you rotate the drive cage. The cage may
pinch the cables and damage them if they are not routed correctly.
10.
If necessary, install a hard disk drive in the carrier:
a.
Remove the locking screws from the sides of the carrier.
Figure 5-39 Removing the locking screws
98 Chapter 5 Replacing components ENWW
To Next Page
Loading...
