7.
Connect the front panel USB (1 and 2), front audio (3), and front power/LED (4) cables to the
system board as shown in the following diagram.
Figure 5-59 Connecting the front panel I/O device cables
8.
Rotate the drive cage down to its normal position.
9.
Replace the front bezel (see
Installing the front bezel on page 74).
10.
Replace the access panel (see
Installing the access panel on page 72).
11.
Restore all connections and equipment that you removed during the
Predisassembly procedures
on page 69.
112 Chapter 5 Replacing components ENWW
To Next Page
Loading...
