5.
Disconnect the power cable (1) and data cable (2) from the rear of the optical drive.
Figure 5-13 Disconnecting the power and data cables
6.
Rotate the drive cage back down to its normal position.
CAUTION: Be careful not to pinch any cables or wires when rotating the drive cage down.
7.
Press down on the green drive retainer button located on the left side of the drive to disengage the
drive from the drive cage (1). While pressing the drive retainer button, slide the drive back until it
stops, then lift it up and out of the drive cage (2).
Figure 5-14 Removing the optical drive
8.
If you are replacing the drive, transfer the four guide screws from the old drive to the new one.
84 Chapter 5 Replacing components ENWW
To Next Page
Loading...
