Solid-state drive (M.2)
Description Spare part number
256-GB SATA-3 self-encrypting SSD 795955-001
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 44).
5. Remove the service cover (see
Service cover on page 45).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
52 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
