Power connector cable
NOTE: The power connector cable is included in the Cable Kit, spare part number 785222-001.
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 44), and then remove the following components:
a. Service cover (see
Service cover on page 45)
b. Hard drive (see
Hard drive on page 46)
c. Optical drive (see
Optical drive on page 48)
d. Keyboard (see
Keyboard on page 57)
e. Top cover (see
Top cover on page 65)
f. ExpressCard assembly (see
ExpressCard assembly on page 74)
g. Audio/USB board (see
Audio/USB board on page 77)
h. USB board (see
USB board on page 78)
i. Speakers (see
Speakers on page 80)
j. Fan/heat sink assembly (see
Fan/heat sink assembly on page 81)
k. Display assembly (see
Display assembly on page 87)
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable (2) from the clips built into the base enclosure.
98 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
