Reverse this procedure to install the hard drive.
Optical drive
NOTE: The optical drive spare part kit includes a bezel and bracket.
Description Spare part number
Blu-ray R/RE DVD±RW SuperMulti Double-Layer Drive 735600-001
Blu-ray ROM DVD±RW SuperMulti Double-Layer Drive 735599-001
DVD±RW SuperMulti Double-Layer Drive 735602-001
Hard drive upgrade bay 734298-001
Before removing the optical drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 44).
5. Remove the service cover (see
Service cover on page 45).
Remove the optical drive:
1. Position the computer with the left side toward you.
2. Loosen the captive screw (1) that secures the optical drive to the computer.
48 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
