c. Optical drive (see Optical drive on page 48)
d. Keyboard (see
Keyboard on page 57)
e. Top cover (see
Top cover on page 65)
f. Fan/heat sink assembly (see
Fan/heat sink assembly on page 81)
Remove the graphics board:
1. Remove the two Torx T8M2.5×4.5 screws (1) that secure the graphics board to the system board. (The
graphics board tilts up.)
2. Remove the graphics board (2) by pulling the board away from the slot at an angle.
Reverse this procedure to install the graphics board.
86 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
