LED board
Description Spare part number
LED board (includes cable) 848246-001
Before removing the LED board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 36).
5. Remove the battery (see Battery on page 37).
Remove the LED board:
1. Disconnect the LED board from the system board (1).
2. Lift to release the LED board cable from the adhesive that secures it to the computer (2).
3. Remove the Phillips PM2.5×3.0 screw (3) that secures the LED board to the computer.
4. Remove the LED board and cable from the computer (4).
Reverse this procedure to install the LED board.
Component replacement procedures 59
To Next Page
Loading...
