HP ZBook 15 G4 - Fingerprint Reader Board

Fingerprint reader board
Description Spare part number
Fingerprint reader board (includes cable)
The ngerprint reader bracket is available in the Bracket Kit, spare part number 848232-001.
850151-001
Before removing the ngerprint reader board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 36).
5. Remove the battery (see Battery on page 37).
6. Remove the solid-state drive (see Solid-state drive (M.2) on page 40).
7. Remove the smart card reader (see Smart card reader on page 45).
8. Remove the hard drive (see Hard drive on page 46).
9. Remove the WLAN module (see WLAN module on page 41).
Remove the ngerprint reader board:
1. Turn the top cover upside down with the front toward you.
2. Remove the Phillips PM2.0×2.0 screw (1) that secures the ngerprint reader board and bracket to the
top cover.
3. Lift the ngerprint reader board bracket o the ngerprint reader board (2).
The ngerprint reader board bracket is available in the Bracket Kit, spare part number 848232-001.
4. Detach the ngerprint reader board cable (3) from the system board.
Component replacement procedures 61