19. If it is necessary to replace the display bezel or any of the LED display assembly subcomponents:
a. Remove the two screw covers (1) and the two Phillips PM2.0×5.5 screws (2) that secure the
display bezel to the display assembly.
The screw covers are available in all LED display assembly subcomponent spare part kits.
b. Flex the inside edges of the top edge (1), the left and right sides (2), and the
bottom edge (3) of the display bezel until the bezel disengages from the display enclosure.
c. Remove the display bezel (4).
The display bezel is available using spare part numbers 734301-001 (for use only on
computer models equipped with a webcamera) and 734302-001 (for use only on computer
models not equipped with a webcamera).
100 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
