Technical white paper Page 17
Note
Verify that the Cache Status LED on the back of the controller is not blinking after the OK to Remove blue LED is illuminated. A blinking
cache status LED means that cache has not been flushed to disk. If the cache light is blinking after the OK to Remove blue LED is
illuminated, call HPE Support. See Figures 7, 8, 9, 10, or 11 for your controller.
Figure 7. P2000 G3 Fibre Channel MSA controller status
Figure 8. P2000 G3 Fibre Channel/iSCSI MSA controller status
To Next Page
Loading...
