To Next PageTo Next Page
Need help?Do you have a question about the HPE MSA 1050 and is the answer not in the manual?
General| Form Factor | 2U |
|---|---|
| Maximum Capacity | 96 TB |
| RAID Levels | 0, 1, 5, 6, 10 |
| Drive Type | HDD, SSD |
| Number of Controllers | 2 |
| Drive Bays | 12 LFF or 24 SFF |
| RAID Levels Extended | 0, 1, 5, 6, 10 |
| Drive Support | SAS |
| Controller Cache | 2 GB per controller |
| Product Type | Storage Array |
| Drive Types Supported | SAS, SATA |
| Power Supply | Dual, redundant |
| Operating Temperature | 10°C to 35°C |
| Host Interface | 1GbE iSCSI, 10GbE iSCSI, 12Gb SAS |
| Storage Type | HDD, SSD |
| Host Interfaces | iSCSI, SAS |
Describes different chassis types and controller models for MSA 1050.
Explains the SMU and CLI interfaces for managing the storage system.
Details the host interface protocols supported by MSA 1050 controller modules.
Details the components visible on the front panel of the enclosures.
Identifies components on the rear panel of the MSA 1050 controller enclosure.
Explains caching mechanisms and the CompactFlash memory card for cache recovery.
Outlines the steps required for installing enclosures and initial configuration.
Details how to connect controllers to LFF/SFF drive enclosures and cabling requirements.
Provides the correct sequence for powering the system on and off.
Lists requirements for data hosts connecting to MSA 1050 arrays.
Explains the host interface protocols (FC, iSCSI, SAS) for MSA 1050.
Explains how to connect hosts to controller ports using various configurations.
Describes the CLI port, its connection, and the emulated serial port interface.
Guides on preparing Linux and Windows systems for CLI connection.
Explains methods for obtaining IP values and setting network port IP addresses.
Explains how to access the Storage Management Utility (SMU) for system management.
Guides on configuring and provisioning the storage system using SMU.
Outlines the basic methodology for isolating faults in the storage system.
Outlines diagnostic steps based on LED indicators and fault conditions.
Explains controller failure behavior and cache data handling.
Guides on isolating faults in host-side and expansion port connections.
Provides links and methods to contact HPE Support and access software updates.
Details HPE's remote support, Proactive Care services, and warranty information.
Introduces LED descriptions for the front panel of enclosures and bezels.
Explains the status indicators (LEDs) on the disk drives.
Details LEDs on the controller and drive enclosure rear panels.
Outlines general safety requirements for system installation and handling.
Details requirements for site wiring and AC power supply for redundancy.
Specifies ventilation requirements and electrical safety guidelines.
Provides precautions to prevent electrostatic damage to the system components.
Details methods for proper grounding to prevent electrostatic discharge.
Guides on locating and understanding SAS fan-out cables for host connections.
