HPE MSA 1050

Controller enclosure—rear panel layout 13
MSA 1050 controller module—rear panel components
Figure 5 shows an 8 Gb FC or 10GbE iSCSI controller module. The SFPs look identical. Refer to the LEDs that apply to the
specific configuration of your host interface ports.
Figure 5 MSA 1050 controller module face plate (FC or 10GbE iSCSI)
Figure 6 shows a 1 Gb iSCSI (RJ-45) controller module.
Figure 6 MSA 1050 controller module face plate (1 Gb RJ-45)
NOTE: For more information about host port configuration, see the topic about configuring host ports within the SMU
Reference Guide or online help.
1 Host ports: used for host connection or replication
2 CLI port (USB - Type B)
3 Service port 2 (used by service personnel only)
4 Reserved for future use
5 Network management port
6 Service port 1 (used by service personnel only)
7 Disabled button (used by engineering only)
(Sticker shown covering the opening)
8 SAS expansion port
1 Host ports: used for host connection or replication
2 CLI port (USB - Type B)
3 Service port 2 (used by service personnel only)
4 Reserved for future use
5 Network management port
6 Service port 1 (used by service personnel only)
7 Disabled button (used by engineering only)
(Sticker shown covering the opening)
8 SAS expansion port
3 4
8
2
= FC LEDs
= 10GbE iSCSI LEDs
157
6
= 1 Gb iSCSI LEDs (all host ports use 1 Gb RJ-45 SFPs in this figure)
3 4
8
2
= FC LEDs
157
6