Technical white paper Page 22
Re-enter controller information
Re-enter the information stored in the controllers, as shown in Table 7.
Table 7. Controller information
This is where the Fibre Channel topology (loop, point-to-point, auto) and port speed (4Gb, 8Gb, 16Gb*, or auto) are assigned. Set
iSCSI port addresses and iSCSI settings if you upgrade and change protocols. Re-enter iSNS and CHAP information.
This includes the system name, contact name, and system location information.
This is where volume host access is assigned.
An example includes assigning user rights to users that are allowed to log on to the array. All custom user names will need to be
re-entered.
Network management services
An example includes enabling FTP access to the array.
This is used for event notification.
SNMP trap address information
This is used for event notification.
Snapshot and Remote Snap licenses
Refer to upgrade considerations section.
Existing snapshot schedules
Schedules of when snapshots are taken or reset, or volume copy schedules.
* 16Gb Fibre Channel is only on the MSA 2040/2042.
Re-enter date and time
Re-enter system settings as follows:
1. Log in to SMU Version 3.
Note
because the user name and password will
return to defaults.
2. From the Date and Time drop-down menu, click Set Date and Time.
Figure 16. Date and time configuration
To Next Page
Loading...
