Procedure
1. Back up all server data.
2. Power down the server on page 23.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Server in rack mode: Remove the server from the rack on page 23.
• Server in tower mode: Position the tower server for hardware configuration on page 25.
6. Remove the access panel on page 25.
7. Remove the PCI air baffle on page 29.
8. Remove the system air baffle on page 30.
9. Open the PCIe slot cover retainer and remove a slot blank.
10. Install the GPU.
80 Hardware options installation
To Next Page
Loading...
