Procedure
1. Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Powering down the server on page 14.
4. Remove the server from the chassis on page 14.
5. Place the server on a flat, level work surface.
6. Install the storage controller.
7. Connect the cable. For more information, see Controller cabling on page 37.
8. Install the server (Install a server on page 18).
9. Powering up the server on page 14.
HPE Trusted Platform Module 2.0 Gen10 option
Overview
Use these instructions to install and enable an HPE TPM 2.0 Gen10 Kit in a supported server. This option
is not supported on Gen9 and earlier servers.
This procedure includes three sections:
1. Installing the Trusted Platform Module board.
2. Enabling the Trusted Platform Module.
3. Retaining the recovery key/password.
30 Hardware options installation
To Next Page
Loading...
