Code 39
Enable/Disable Code 39
Enable (Default) Disable
Check character verification and transmit
Code 39 barcode data does not contain a check character. If there is a check character, it is the
last character of the data. A check character is a value calculated from all data to verify that the data
is correct.
Not check (Default) Check
Transmit check character
Transmit check character Disable (Default)
Enable/Disable code 39 Full ASCII
Code 39 data can include all ASCII characters, but the reader can only read part of ASCII characters
by default. Through setting, the function of reading full ASCII characters can be turned on.
Disable (Default) Enable
To Next Page
Loading...
