Convert Code 39 to Code32
Enable Disable (Default)
Code 32 prefix
Enable add prefix character "a" Disable (Default)
Code 93
Enable/Disable code 93
Enable (Default) Disable
Code 11
Enable/Disable code 11
Enable Disable (Default)
Check Setting
Code 11 barcode data does not contain the check digit. If there is a check digit, it can be the last
one or two characters of the data. The check bit is the value calculated from all data to check whether
the data is correct. Therefore, if it is set to "Not check", the reader will normally transmit all barcode
data.
To Next Page
Loading...
