Host mode (CDC, HID, BT, COM） ........................................................................................ 44
Trigger mode (Single scanning, scanning continuously, auto sensing) ................................ 44
Default parameters (Restore factory settings) ..................................................................... 44
Decoding timeout（0.1s~9s） ............................................................................................ 44
Data prefix ............................................................................................................................ 45
Data suffix ............................................................................................................................ 45
Aiming device (ON/OFF) ...................................................................................................... 45
Illumination light (ON/OFF) .................................................................................................. 45
Baud rate of virtual serial port ............................................................................................. 47
Check bit of virtual serial port .............................................................................................. 47
Multi code quantity .............................................................................................................. 47
Multi code sensitivity ........................................................................................................... 47
Buzzer enable ....................................................................................................................... 47
The convert rate in HID mode .............................................................................................. 48
Timeout setting of the same barcode in non-single scan mode .......................................... 48
Sensitivity ............................................................................................................................. 48
Center aiming decode setting .............................................................................................. 48
Virtual serial port mode command settings ................................................................................ 50
Barcode function settings ............................................................................................................ 51
ITF cut the first few bits of data ........................................................................................... 51
Convert grouping character to space ................................................................................... 51
Remove zero data at the beginning of barcode ................................................................... 51
Remove or reduce space ...................................................................................................... 51
Skip the number of characters before barcode data ........................................................... 52
Skip the number of characters after barcode data .............................................................. 52
Barcode data case conversion .............................................................................................. 52
Insert characters into barcode data ..................................................................................... 54
Compound command parameters ....................................................................................... 54
Common suffix ..................................................................................................................... 54
Appendix Ⅰ Barcode Enabling Settings ...................................................................................... 55
Appendix Ⅱ Data code prefix and suffix ..................................................................................... 57
Appendix Ⅲ ASCII Code Table .................................................................................................... 64
To Next Page
Loading...
