Safety
HTC 420 VS
6 2.0
Note!
The instructions in this manual must be followed in order for the
CE mark to be valid.
Note!
The machine may only be lifted using the intended lifting eye.
Note!
The machine is best stored in a warm (above zero), dry area when
not in use.
Note!
If the machine is stored in a cold area (below zero), it must be
stored in a warm area (above zero) for at least two hours before
use.
Note!
When dry grinding, a suitable dust extractor should be used.
Contact HTC for model recommendations.
Note!
After removing glue and wet grinding, always lift up the grinding
heads so that they do not stick to the floor and damage machine
components and the floor when restarting.
Note!
When wet grinding, the water tank must be filled with water. Only
cold water with no chemical additives may be used.
To Next Page
Loading...
