Maintenance and repairs
HTC 420 VS
22 2.0
• Check that the upper belt is undamaged. Try to turn the
large disc in one direction. It should be quite stiff. If it turns
freely, the belt has come off.
Tip!
Recondition all the grinding holders at the same time.
5.5. Every month (or 100 hours)
• Tighten anything that may have vibrated loose.
• Remove the grinding cover and check that it is undamaged.
• Check the upper belt. Replace, if necessary.
• Check the seals on the shafts that the upper belt runs on.
Replace, if necessary.
• Scrape and vacuum-clean the parts shielded by the grinding
cover.
• Test run and listen for any dissonance from the bearings.
5.6. Repairs
Any repairs that may be required must be carried out by a HTC
Service Centre, which has trained service personnel and uses
HTC original parts and accessories. Contact your retailer if your
machine requires servicing. For contact information, see Contact
Information at the start of the manual.
To Next Page
Loading...
