HTC 420 VS - Table of Contents

HTC 420 VS
Table of contents
Table of contents
1. Introduction.........................................................1
1.1 General......................................................................... 1
1.2 Liability.......................................................................... 1
1.3 Manual.......................................................................... 1
1.3.1 Safety instructions – explanation of symbols........1
1.4 Transportation............................................................... 2
1.5 On delivery....................................................................2
1.6 Unpacking the machine................................................ 3
1.7 Machine name plate..................................................... 3
1.8 Handling and storage................................................... 3
1.9 Vibrations and noise..................................................... 3
2. Safety...................................................................4
2.1 General......................................................................... 4
2.2 Warnings....................................................................... 4
2.3 Observations.................................................................5
3. Machine description.......................................... 7
3.1 General machine description........................................7
3.2 Description of controls – Control panel........................ 9
4. Operation...........................................................11
4.1 General....................................................................... 11
4.2 Handle settings........................................................... 13
4.3 Access to grinding tools............................................. 13
4.4 Fitting and replacing grinding tools.............................14
4.4.1 Fitting grinding tools........................................... 14
4.4.2 Changing grinding tools......................................15
4.5 Preparations for dry grinding...................................... 16
4.6 Preparations for wet grinding..................................... 17
4.7 Control........................................................................ 18
4.7.1 Standby ............................................................. 18
4.7.2 Emergency stop switch...................................... 18
4.7.3 Starting the machine.......................................... 18
4.7.4 Overload............................................................. 19
4.8 Making operation easier............................................. 20