HTC 420 VS - Handle Settings; Access to Grinding Tools

HTC 420 VS
Operation
2.0 13
4.2. Handle settings
The picture below shows the handle positions on the machine.
1
2
3
Figure 4-1 Handle settings
1. The forward position - used, for instance, for
transportation, as the machine takes up significantly less
space.
2. Rear position - used for tipping the machine to make tool
replacement easier.
3. Working position - the working height can be adjusted to
two positions using the machine’s adjustable handle.
• Lock the handle in the required position using the locking
mechanism located on the underneath of the handle cover.
4.3. Access to grinding tools
Warning!
After grinding, the tools will be very hot. Tip the machine back
and allow it to stand for a short while. Use protective gloves when
removing the tools.