HTC 420 VS - Description of Controls - Control Panel

HTC 420 VS
Machine description
2.0 9
3.2. Description of controls – Control
panel
The picture below shows the machines control panel:
Figure 3-3 Control panel
1. Power - Standby indicator: Indicates that the
machines functions have been activated. Lit
when the Power knob (7) is turned to “I”.
2. Overload - Overload indicator: Lights up to
indicate that the machine is using too much
power. If this is ignored, the power supply to
the motor will be interrupted and an error code
generated.
3. Reset - Resetting the electronics: If the
machine experiences an error, it may be
necessary to reset it. Turn the Grinding knob
(5) to “Reset” to reset all electronics. The
knob automatically returns to the central
position once it is released. Any error code is
shown on the display in the control cabinet.
4. FWD - Forward: Turn the Grinding knob (5)
to “FWD” to start the machines grinding discs.
5. Grinding - “Reset” (3) and “FWD” (4) knob.
6. Speed - Rotation speed: Regulates the rotation
speed of the machine’s grinding discs.