Operation
HTC 420 VS
16 2.0
Figure 4-4 Removing grinding tools
2. Slide the grinding tool diagonally from above down into
the appropriate guide slot on the tool holder - see Figure
4-2 on page 14. Then push the tool fully into the guide
slot.
3. Lock the grinding tool into the tool holder by giving
it a few light taps with a rubber hammer - see Figure
4-3 on page 15.
4.5. Preparations for dry grinding
Warning!
Check that the splash guard is fitted.
1. Connect a dust extractor to the machine. For dust extractor
models, see under the Suction System tab in the HTC
Product Catalogue.
To Next Page
Loading...
