4. The LED starts to flash.
5. When the LED stop flash, remove the USB memory
stick.
6. Go to "Service" and press "OK".
7. Press "OK".
8. Select "Service Settings" and press "OK".
9. If the update is not done correctly, select "Reinit
set", press "OK" and do the update procedure again.
5.5 To do a pairing operation between the
product and the remote control
1. Push the radio button on the control panel.
2. Push the green button.
3. The symbol on the display and the LED on the radio
button start to flash.
4. When the LED has a constant light and the symbol
does not flash, the pairing operation is completed.
950 - 001 - Prepare and do servicing on the product - 17
To Next Page
Loading...
