2 Safety
2.1 Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING: Used if there is a risk of injury or
death for the operator or bystanders if the
instructions in the manual are not obeyed.
CAUTION: Used if there is a risk of damage to
the product, other materials or the adjacent area
if the instructions in the manual are not obeyed.
Note: Used to give more information that is necessary in
a given situation.
2.2 General safety instructions
• Read and obey this workshop manual.
• Obey the local safety regulations when you repair or
do servicing of the product.
• The safety equipment you use must obey local
regulations.
• Use only the equipment that the manufacturer
recommends.
• Use personal protective equipment.
• Use protective gloves and safety glasses. The safety
glasses must obey the ANSI Z87.1 for US or EN166
for EU countries.
• Use earmuffs when the product is in operation.
• Always stop the product before you repair or do
servicing of the product.
• Remove flammable materials from the work area.
The product can cause sparks.
• Do not use the product if the power cord or cables
are damaged.
• Disconnect the product from the mains socket.
• If possible, keep the power cord disconnected when
you repair or do servicing of the product.
• Use cables adapted to outdoor operation.
• Do not touch the wires when the product is on. An
electrical shock can cause injury.
• Do not point compressed air to your body.
Compressed air can go into the blood stream.
• Always tighten the nuts and the bolts on the product
correctly.
• Do not use the power cord to lift the product. Do not
pull the power cord to disconnect the product.
• Do checks of the product for warning labels that are
damaged. Replace the warning labels that are
damaged.
• Always read the warning labels of product supplies.
• Obey the local waste regulations.
2.3 Special safety instructions
The product has 2 emergency stop buttons. 1
emergency stop button is on the control panel and 1 is
on the remote control.
WARNING: Voltage stays in the product after
the emergency stop button is pushed.
2.4 Electrostatic discharges (ESD) protection
CAUTION: Electrostatic discharges can cause
damage to the product.
Most semiconductors, such as electrical enclosures,
radio units, control panels, and drive motors are
sensitive to electrostatic discharges (ESD). Parts of
different materials that are rubbed against each other in
the product can cause electrostatic charges. When a
charged part is touched, there is an electrostatic
discharge. The electrostatic discharge can cause
damage to the sensitive semiconductors.
There are different accessories that can make sure that
electrostatic discharges do not occur to the components:
• Antistatic bags to send the components in. In the
bags, components are safe from external
discharges.
• Conductive mats and wristbands connected to the
ground are used at workplaces. They give the
4 - Safety 950 - 001 -
To Next Page
Loading...
