7. Clean the filter: Quickly press on the button to to
clean 1 filter. Hold in the button to do a dust drain.
8. "EXTRA" : ON/OFF.
9. Joystick. Steers the product left/right and controls
the speed and direction of rotation of the grinding
head.
10. Emergency stop button.
11. Increase and decrease water supply.
12. Set mist cooler system ON/OFF.
13. Bracket for harness.
14. Control for the grinding head. Left/right or stop.
15. Increase or decrease the grinding head speed.
16. Increase or decrease the movement speed of the
product.
17. Control for direction. D: forward, R: rearward, P:
parking brake.
18. Control the left/right deviation of the product when it
is in operation.
19. Front lamps, ON/OFF.
20. Rear lamps, ON/OFF.
21. Start and stop the dust extractor.
22. Start radio communication between the remote
control and the grinder.
23. Remote control ON/OFF and key code for the radio
unit.
24. Socket for cable control.
25. Battery.
6.6 Overview of the receiver for the remote control
Position LED LED sig-
nal
Description
1 "POWER"
Off The receiver has no power.
On The receiver has power but has no connection to the remote control.
Flashes The receiver has power and is connected to the remote control.
2 "ALARM"
Off The receiver operates correctly.
On Something is defective.
Flashes Fault in emergency stop circuit.
3 "RUN"
Off The CAN network is not in operation.
On The receiver does not use the CAN bus.
Flashes The receiver is connected to the CAN bus network.
4 "ERR"
Off The CAN bus operates correctly.
On The CAN bus is not connected to the CAN bus network.
Flash The CAN bus is defective.
950 - 001 - Function overview - 21
To Next Page
Loading...
