6. "OK" for approval of menu selections. To reset
distance gauge, press some seconds.
7. Go back in the menu structure.
8. Set radio communication ON/OFF.
9. Set mist cooler system ON/OFF.
10. Set water supply ON/OFF.
11. Increase and decrease water supply.
12. USB port to charge mobile devices.
13. Lights: 1. All lamps come on. 2. Front lamps come
on. 3. Rear lamps come on. 4. All lamps go off.
14. Start and stop the dust extractor.
15. Clean the filter: Quickly press on the button to clean
1 filter. Hold in the button to do a dust drain.
16. "EXTRA": ON/OFF.
17. Emergency stop button.
18. Increase or decrease the grinding head speed.
19. Change direction of rotation of the grinding head.
20. Start/Stop the grinding head.
6.5 Overview remote control
1 2 3
4
6
5
7
8
9
10
11
15
17
19
22
25
24
23
20
21
16
14
12
13
18
1. Menu button for future functions.
2. Move right/left in the menu and change the
information that the operation gauge shows.
3. Move up/down in the menu and change the screen
saver.
4. Menu button for future functions.
5. Display, refer to
Overview of the receiver for the
remote control on page 21
.
6. Status indicator.
• LED is off: The remote control is off.
• Green LED flashes quickly: The remote control
is not connected to the product.
• Green LED flashes slowly: The remote control is
connected to the product.
• Red LED is on: The emergency stop is engaged
or there is a fault on the remote control.
• Red LED flashes: The battery state of charge is
low.
20 - Function overview 950 - 001 -
To Next Page
Loading...
